Products
Contact Us
Phone : +86 0531-85908792
Email:Admin:zrsuns@outlook.com Sales:sales@rlaserpowersupply.com
Skype: ZRsunslaser
Q Q: 2407603284
Mobile :+86-13295411923
ZR-80WE CO2 laser power supply
1. This 80Watt laser power supplies is used to drive most brand 1200-1450mm CO2 laser tube. The two fans laser power supplies use zero-current half-bridge soft-switch circuit to make sure the CO2 laser power supplies have high efficiency.
2.This two fans laser power supplies has RED TEST button to easily figure out CO2 power supplies or CO2 laser tube’s failure. It is very easy and simple to remove trouble.
3.Input analog signal(0~5V) or PWM is used to control the output laser power on this 80Watt laser power supplies.
ZR-80WE CO2 laser power supply
Feature:
1. The CO2 laser power supplies have H/L/P/G/IN/5V control signal interface,The upper cover and bottom shell are made of aluminum Casing is galvanized sheet.
2. Aging check before stored in warehouse:
3. This high voltage laser power supplies’s control interface is applicable to high/low level signal. TTL level is to control the on/off of the laser power with a protective switch to check water-flow and ventilation.
4. Each 80Watt laser power supplies before selling will go through the aging check:
(1) sustain 10 hours at temperature 60 Degrees Celsius under full-load condition;
(2) 500 times on/off check for 7 seconds.
5. Input analog signal(0~5V) or PWM is used to control the output laser power on this 80Watt laser power supplies.
6.This two fans laser power supplies has RED TEST button to easily figure out CO2 power supplies or CO2 laser tube’s failure. It is very easy and simple to remove trouble.
7. This 80Watt laser power supplies is used to drive most brands 1200-1450mm CO2 laser tube. The two fans laser power supplies use zero-current half-bridge soft-switch circuit to make sure the CO2 laser power supplies have high efficiency and fast response speed.
Specification:
lnput | Input voltage | AC220V±10% (AC110V specified while order) | ||
AC frequency | 47~440HZ | |||
Maximum input power | 750W | |||
Maximum input current | 3.4A | |||
Output | Maximum output voltage | 32KV | ||
Maximum output current | 33mA (depending on the laser tubes of different manufacturers) | |||
Efficiency | More than 90% (Full load) | |||
Response speed | Not more than 1ms | |||
Control lnterace | TTL multilevel switching control,effective level can be high and low selection (see control wining diagram) | |||
Insulation | lnput-output | AC 1500V 1 minutes not more than 10mA | ||
lnput-shell | AC 1500V 1 minutes not more than10mA | |||
Output-shell | Connection | |||
Open Circuit Protection | Can be short circuit (requires a good grounding shell,while avoiding the positive electrode and the shell between the arc) | |||
Environmental Requested | Working temperature | -10℃~50℃ | ||
Storage of temperature | -20℃~75℃ | |||
Relative Humidity | Maximum 85%RH (non-condensing) | |||
Altitude | 100,000 feet of work 200,000 feet of storage,dose not work | |||
Cooling methods | Forced air cooling (fan cooling) | |||
Dimensions (LxWxH) | 283mmx178mmx106mm |
- Previous:ZR-60W CO2 laser power supply
- Next:ZR-50W CO2 laser power supply
Telephone contact
TELEPHONE
+86-539-8058588
MOBILE PHONE
086-13295411923